Jump to content
HybridZ

Leaderboard

Popular Content

Showing content with the highest reputation on 07/01/18 in all areas

  1. Well, I suppose I should probably update this as it's been awhile. Nothing too huge going on though, just some cosmetic fine tuning in the engine bay. - Replaced all the hardware with fresh yellow zinc plated - New plated water pump pulley, and block off plates. - Made a throttle cable bracket for the Mikunis and eliminated the j-arm that went to the firewall bracket. - Made a new heatshield for the carbs. Bit of a frankenstein's monster, but it seems to work. 2 sheet of aluminium, some Nimbus GII (waffle) between them, and reflective gold tape in the underside. It now mounts onto the front of the carbs via a custom bracket. Pain in the A to remove, but less visually intrusive and it made room for the throttle cable bracket. - Painted the strut bracing brackets matte black. - Removed blue anodising from some AN fittings. - New Magnecor KV85 ignition leads. It was fun buying the universal kit and being able to route them however I wanted. - Red wrinkle powder coated the valve cover. Reckon that's about it for the under the hood now. Very happy with how everything looks! Threw in a few shots of the car too, just for fun ,:)
    1 point
  2. These guys sell shims that thick and thicker. http://www.precisionshims.com.au/products/slotted I have them in my engine and would recommend them.
    1 point
  3. Better late than never, I suppose? A few points The mock-up wheels are way too big (18s) but they are what I had on hand at the time. The garage is terribly messy. I am an amateur and have no idea what I am doing.
    1 point
×
×
  • Create New...