Laurel1800

That D should be a B..

Thanks but i already found the mckinney ones, i am after something a bit more affordable. So many sr20 swaps on here surely someone must have made up some mounts or took measurements of the mckinney ones to copy them?

Engine and gearbox mounts or drawings so i can make them myself.

Good point Frank, Jack that car of you is looking amazing and i really hope i can see it in the flesh some day!

Ziet er prachtig uit Jack, ik hoop dat ik de wagen eens in het echt tegenkom!

i was just wondering about how to install these properly. I guess they have to be fitted under the same angle, same height? or is the rest of the suspension all adjustable so that any imperfections on the camber plate install will not be an issue when alligning the car?

Still have the rusty ones? Just make new ones from new steel, its just straight pieces of metal, nothing to hard to duplicate.

well, i think i must see the inside of this barn filled with Z's too

thanks, i know that switch is the rear defogger but what is that extra wire fore? the switch uses two wires.

what is this for? and what is that extra wire for?

Seriously? I have never heard of it and you know about it? I need to go there too now i know of it beinig there somewere.

Whats Franks Barn?

Thanks Thats info i can work with I took them aparft and cleaned them out, that fixed a lot of the problem, now some fine adjustments and i guess they are good to go.

Well here's a pic of what they look like: they are round, but flat. I have no idea about their sizes. I posted the same pic on ratsun, they say these are hitachi sidedrafts, no needles. Is what they said on ratsun forums. So they are similar to 240Z carbs then?

but these carbs are on the bluebird from the factory so why should i change needles?