Jump to content
HybridZ

Ba280z

Members
  • Posts

    8
  • Joined

  • Last visited

About Ba280z

  • Birthday 11/06/1985

Profile Information

  • Gender
    Male
  • Location
    Tennessee

Ba280z's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. I have a autech tuned rb20det out of a r31 or a cefiro. not sure if its a nicu or eccu engine.
  2. Need help. I'm trying to locate the wires on the same loom as my afm. This is the only plug I have and not sure which need constant and switched power.
  3. I have my RB in but having trouble locating the wires next to the AFM that need power. Does anyone have a pic of it?
  4. I have a 78z with a rb20det. Engine is bolted in but the trans mount is about an inch away from lining up. I'm using the RB mount. I know in post that it says use the stock z mount. But does it offset that much to fit? Or am I way off?
  5. I'm in the process of doing the swap but I'm having trouble with wiring. I have an autech rb20det full swap. Trouble I'm having is my harness and ECU are different then the write ups. My ecu has four separate plugs instead of the block that plugs and bolts in. And my pin out is alot different. If anyone is familiar with this some help would be great.
  6. I'm also in the process of doing the swap but I'm having trouble with wiring. I have an autech rb20det full swap. Trouble I'm having is my harness and ECU are different then the write ups. My ecu has four separate plugs instead of the block that plugs and bolts in. And my pin out is alot different. If anyone is familiar with this some help would be great.
  7. is this thread still going I need help with wiring. I have a rb20det swap, and harness and ecu are different then everyone elses ive seen. the pin out on ecu are different and so is the wiring. it has 4 separate plugs for the ecu instead of the block that bolts in. just trying to figure out the wiring I need. if anyone is familiar with this some help would be great!
×
×
  • Create New...