The240zProject

I like all but the blue.. I cant pic a favorite... maybe the orange?

shoot me an offer. I'm going to search this board and ebay to see their value and then we will work out a deal. I dont need them.

More of the snapper car. http://forums.hybridz.org/showthread.php?t=156137

http://forums.hybridz.org/showthread.php?t=156171

I need the hinges and all bolts/washers for a driver side door. I also need the door latch (not the handle) and stopper for the same door. Basically all I have in my possession is a bare door with handle and need the rest of the hardware. I do have the window tracks and trim. Also need a passenger side headlight bucket. Thanks in advance Located in Indiana.

I was going through some boxes that the previous owner of my 240z boxed up and found these things. wtf are they? Some are covered in dust but i have no idea what they are? Almost look like wheel center caps? About 3" wide and have metal prongs on the back.

i just went out and measured the gap between my tail light and 1/4 panel without the filler panel in. Its roughly 1.5". Same as the width of the filler panel itself.

did you attempt to rattle can that flat black!??! With those wheels and that kit... why cheap out on the paint!??

26mm??? Thats 1.02 inches... the size of a quarter. That would be one VERY SMALL caliper piston.

bump

You are correct, his are technically too high. Source Schrothracing:http://www.schrothracing.com/docs/Co...structions.pdf http://www.fiainstitute.com/documents/driver_guide.pdf http://www.trackpedia.com/wiki/Safety_at_the_track

in for more.

?

I've always drooled over this roadcorase car http://www.cardomain.com/ride/2978513 Is his body based off of the same YZ kit as you have?

Thanks for the info. So the Ls2 has a different intake when its from a RWD Trailblazer SS? This isnt an iron block LQ4.