Jump to content
HybridZ
Rob240z

280z r200 differential pinion flange wanted

Recommended Posts

I'm trying to swap a 280zx r200 in my 240z. The pinion flange on the diff is not the size I need. I already have a driveshaft that I would like to use. I need the DAT-110 with 2.75 bolt circle. In the picture below it is the one on the left. I need the bolt too.

 

Thanks,

Rob

 

9285893905_ecdeec1baf_o.jpg

 

 

Share this post


Link to post
Share on other sites

Sounds great, thanks a lot!

 

I'm 99% sure it is from a 280zxt. That is what the guy I bought it from told me. I bought a T-5 with the drive shaft from him too and the drive shaft hooks up to it. I'm not going to be using the T-5 anymore though. I'm sure I'll be listing it for sale at some point as I don't need it anymore.

 

This is the second time you have helped me out with a part I needed. I really appreciate it.

 

Thanks again!

Share this post


Link to post
Share on other sites

That looks like the one!

 

I don't have your address anymore. Could you send me a pm with it?  

 

I still have your paypal info it is the same? Let me know how much shipping is. 

 

Here are a couple of pictures of the one I will be sending you.  Wow, these are very hard to remove from the diff!

 

If everything sounds good I'll send it out tomorrow.

 

Thanks,

 

9294910103_8e6212bc64_z.jpg
IMG_2809 by Rob Olejniczak, on Flickr
 
9294909801_fdfaf01327_z.jpg
IMG_2811 by Rob Olejniczak, on Flickr

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

×