Jump to content
HybridZ

JEEP Throttle Body and Sensors


Project1

Recommended Posts

This might be a stupid question, if it is just tell me.  I have been reading and trying to understand setting up my frist MS. 

 

I was wondering if it would work well to run a jeep TB, then can come in a 62mm bore, and have a map, IAC, and a TPS attached.

 

Any thoughts

 

TBtop.JPG

Edited by Project1
Link to comment
Share on other sites

I saw some people do that, but I still some people run them ..and some people run two in altitude (have two specific air/fuel mixtures).

 

I'm still learning about ms. 

 

Do anyone use any other TB, for sensor reason?  Or is there any other factory or aftermarket parts that people have had good luck with for using with their sensors, like the jeep TB above that has the sensors built in?

Edited by Project1
Link to comment
Share on other sites

The ka24e throttle body will bolt right on and has a usable tps. You'll just need to connect the throttle linkage. I personally do not use iac or fast idle.

ok awesome, thats the plan I will start with. Thanks Skirkland, I appreciate your help!

 

Is the tps on the ka24e plug and play with MS, like the GM sensors?

Edited by Project1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...