Jump to content
HybridZ

Recommended Posts

Hello everyone, I just ordered s12w calipers, 84 300zx rotors, 1 inch wilwood master cylinder, and hub spacers from silvermine motors for my 73 240z. I have 14x7 mesh wheels. Well my concern/question is if I will need a wheel spacer? I would like to get the spacers now if I need them rather than wait until I already have everything going together and get held back. Any help or information would be greatly appreciated. Thanks

Link to comment
Share on other sites

You will most likely need them, I've seen someone saying that they didn't but both of my 14" sets and the 15" snowflakes on my car now needed small spacers to clear. The 14" slot mags I used to have needed a 1/4" spacer and the snowflakes now have 3/8" spacers. I swapped the original lug studs for some rear studs from a 1990s Nissan Quest that are the same knurl and thread size as stock, just 12mm longer to give you the thread engagement needed to compensate for the spacers. Dorman part# 610403, IIRC.

 

Hope that helps

Link to comment
Share on other sites

  • 3 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...