fast300zx

Ok yeah i forgott to mention that. why would you run higher cr and lower boost for a drag car. Could someone explain this? thanks

opps i meant 25 not 15 sorry.

Ok here is the deal i wanna get peoples opinions on higher compresion and lower boost or lower compression and higher boost. Ok so I did the math and found at 8.1 to 1 running 28 lbs of boost I would get the same final compression ratio as if I were to run 9 to 1 at 15 lbs of boost. So I will make a poll High or low compression.

ok thanks. I plan on running a manual because I like them. I understand it wont be as consistent and everything but that is just part of the fun for me. thanks

hello?

That would be bad ass. When I start restoreing my z31 I might try and get some.

The car will be raced on a drag strip as that is all we really have around here. I Would like to have the ablity to make 700hp before nitrous.

Ok

Ok well afer more research and satans help i have an idea. So here goes. I plan on running the je pistons, eagel rods, complete head work, advanced fuel system,romulator, A Tec2 stand alone,ported intake with q45 tb, 88 turbo tranny and rear end. Ok my big question is where can I get custom 1/2 inch fuel rails for a vg30et and what compresion ration should I run. From what I figure you can only run 12 to 1 on pump gas. So what I am trying to figure out is what compresion ration should I run and what boost to run. I am thinking 8 to 1 20+ pounds of boost. I am trying to make 600-700 hp. Any other information I may have left out ask and I will tell you. I am at sea level. All the charts and equations I have done sit me at such a high final compresion ratio I would have to run nine psi which I think is a bit low. Any help would be apriciated. thanks

Ok well i figured it out. My starter is gone. I am getting a new vg30et motor with tranny. So its all good.

I think it looks pretty cool. It is very odd but at least it isn't the same old thing over and over.

ok thanks

i went there and cant find much is the first page all the info they have? thanks

i was looking at JWT 4bar injection system for the z31 vg30et and was wondering if it would work with around 600-700hp. Also what other injection options are there. I plan on completely re working the engine. I would like to know what kind of rods would be best. I plan on using the car for drifting and drag racing, and some scca. I know you cant build a multi purpose car so i will do the best i can. Drifting seems fun and drift and drag is all we really have here so i will mostly focus on that. I would just like to know what brands are good and at an reasonable price. For pistons and rods. I also plan on upgradeing the turbo but i am not sure what i want to run yet. I would like to make a ton of boost IMO 20-30lbs should be achevable but i am not sure I have only delt with turbos on desil engins. thanks

ok the that explains alot the gronds are not connected. i will put them so you all can see. i amgoing to do a full tune up and clean it up nice and sell it then buy this guys 88 that i just need. lol thanks