Jump to content
HybridZ

MY77Z

Members
  • Posts

    465
  • Joined

  • Last visited

About MY77Z

  • Birthday 04/30/1980

Profile Information

  • Gender
    Not Telling
  • Location
    KUWAIT

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

MY77Z's Achievements

Newbie

Newbie (1/14)

10

Reputation

  1. hey guys, am back after 5 years maybe LOL been busy with life and left my Z alone for few years, now its time to get back to her... just a small question about Brian's engine cradle...did any of you guys install it with an EFI engine?? i just wanna know if its possible to run EFI with the stock hood. cheers Ali
  2. Holly $hit, the engine bay looks even better
  3. i'm in love that is what you get when you mix up 2 great cars, you end up with a sexy, awesome, amazing, astonishing (excuse my english) car, congrats and any vids yet ??
  4. ok, let me get it guys, so with this dress she's a S281SC, drop the dress and i would say a S281 Extreme
  5. and Kuwait, don't forget that we started the whole drag racing, street racing thing here in kuwait back in the 70s where UAE started in the mid 90s.
  6. heeey, why calling 6-8 companies when we have you Grumpyvette here on this forum??
  7. this is the link for the chevy pullies, not sure which one will work best for you since i'm not a chevy expert at all http://store.summitracing.com/egnsearch.asp?Ntt=March+Performance+Aluminum+Serpentine+Water+Pump+Pulleys&N=700+4294908216+4294840140+115+4294845111&Ntk=KeywordSearch hope this will help you
  8. ok, i have a 302 ford but a belt is a belt and a pully is a pully i'm running a Vbelt with the ribbed side on the flat water pump pully, i dont think it will fail or throw the belt, but it will slip alot giving that squeeky annoying noise whenever you start the car or rev it. here you can see how the belt marked the WP pully installed i would recommend that you buy a water pump pully with grooves, that's what i did, i ordered mine from summit and its about 79 bucks. http://store.summitracing.com/partdetail.asp?autofilter=1&part=MCH%2D2004&N=700+0&autoview=sku check them out.
  9. another question, can i buy an aluminum drive shaft and weld this adapter to it??
  10. guys, no one has an idea? anyways, i ordered the part from JTR, should recieve it here in Kuwait next week and than i'll be able to know if it fits or not thanks again
  11. looks like a well built car, was thinkin about buying it and bringing it here in Kuwait, how much it's worth??
  12. Hi Kevin, i have a question about the ford ITB setup, do i need a special wiring harness?? or the stock one would work? never had ITBs before so i have no idea about wiring them. if the stock harness works, what would i do with the plug that goes to the MAF sensor?? would you explain it please.
  13. hi guys, was wondering if the JTR part #DAT-110 would fit on a stock 1988-1993 mustang drive shaft?? it uses a 1310 u joint, same as the ford's joint but just wanted to make sure. thanks
×
×
  • Create New...