Jump to content
HybridZ

Dj Technick

Members
  • Posts

    3
  • Joined

  • Last visited

About Dj Technick

  • Birthday 01/16/1990

Profile Information

  • Gender
    Male
  • Location
    Des Moines, IA

Dj Technick's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. Just ran home for lunch to check and realized its an r180. Has a tall and skinny looking rear cover. Thanks for the help everyone.
  2. I'll have to take a picture when I get home to verify that it's an R200. I'll also post a picture looking into both sides. I bought it from a junk yard and they said they polled it out of a 79 N/A manual trans 280zx. I called them again today to verify that's what it came out of and they said that's what it was from and explained the whole bolted u joint bit to me.
  3. I've tried searching but haven't had much luck. Recently I purchased an R200 from a 280zx, when it arrived it didn't have the output/side flanges in it. When looking inside I noticed the center had a block in it with a threaded hole. I called the person I bought it from and was told this style didn't have side flanges and the u joint had a long bolt that went through and held it in place rather then a snap ring. My question is, can I use the snap ring style side flanges in it? If not am I able to have a shop swap the 280z R200 center that uses the snap ring flanges in it without any issue? Sorry if these sound like dumb questions.
  4. In need of a crank pulley for my 76 280z, the one I have seperated into 2 peices and it's the only car I have to get to and from work at the moment. If anyone has one they would like to sell for a decent price my number is 515-249-9531 I'm located in Des Moines, IA 50321
×
×
  • Create New...