flyboy2

Speed hut

I was able to find a freeze plug that was the same size (Dorman P70C). All I Had to do was to bore a hole in it (I don't recall the size). Worked great.

I think this is what you are looking for: Advance Auto Part No. 1-0029BF[/u].

I haven't purchased on yet. I have 500 miles without any pre-filter. I believe I read that the pump will handle up to 100 microns. I would think any filter, in that range, with sufficient capacity would be ok. This is the filter I was using http://www.summitracing.com/parts/SUM-230101/

I think I used the same pre-filter you are using. I had nothing but fuel starvation problems. I removed the filter and it has been fine for 500 miles. I think that the element is too small, lacking enough area. My filter came with a 40 micron screen.

Thank you for your reply Cable, What I ended up doing was to remove the fuel supply and return lines and used a 3/8 supply. The vent line was re bent and run to the front of the right frame rail. I can either install a charcoal canister ot just put a small filter on it to keep stuff from plugging the tube.

I will double check tonight.

This should be what you are looking for: Tilton # 75-750U

What did you guys do with the fuel vent line that runs to the engine bay? Just leave it open, remove it and seal it at the tank? I am ready to install a LY6, but I want to take care of this line before the engine goes in. Thanks