dandyZ

JTR manual. Adapter plug on ebay

I have 1 pass. side metal bucket $25 + $6 shipping. Dan

Just noticed that you guys (silver car and blue car) don't have vented hoods. Louvered inspection lids look great.

Header blankets about $80.

Anyone have this set-up? I don't want or need a 5 speed. MPG is not a concern. I guess the question is, bellhousing compatability... I appreciate anyone's input. Dan

I believe blackdragonauto.com carries those.

Before purging completely I was running 200-220. After, 180-190. Have you blocked off the area in front and below the rad. and around the supports so all the air is flowing through the rad.? This has been covered ad nauseum on this forum. It does make a big difference.

I have a fender. Located in S. Oregon. $50 + shipping Dan

Also, make sure you have purged the air out of the system. Jack up the front of the car and burp the air out with cap off. I had a problem with a new aluminum radiator until the system was cleared of air.

I have a bracket ready to go. Had to drill out the spot welds to remove it. I also have the latch/cable. $25 for the bracket. $40 for everything. Dan Also pm'd you. Send me your email and I can send pics if you like.

I have a bracket ready to go. Had to drill out the spot welds to remove it. I also have the latch/cable. $25 for the bracket. $40 for everything. Dan Also pm'd you. Send me your email and I can send pics if you like.

Are there any infinity or lexus trans. that would be compatible? W/ custom bellhousing.

Still need the firewall bracket?

Word to the Mother Ship.

I have a car that could possibly accommodate your needs. It is a 73. These would have to be cut off the car, correct? I am in southern Oregon so shipping shouldn't be too bad. Let me know. Dan