Jump to content
HybridZ

Leaderboard

Popular Content

Showing content with the highest reputation on 05/21/19 in all areas

  1. Sometimes people discover that the rear caliper bleed screw hole is not actually the highest point when installed after these conversions, because they're not designed for Z cars. It's close but still has a spot for an air bubble. They have to unbolt the caliper and rotate it so that the channel to the bleed port really is the highest point. They bleed the brakes with the caliper loose, then rotate it back and bolt it down when they're done. Be the bubble.
    1 point
  2. This thread really helped me out; I recently bought a '72 240 off of eBay. It was great but the drivers side door had to be slammed to the point of concern or it would not fully latch. From inside the car it was very difficult. After finding this thread in a bout of restlessness last night; I went to Lowes and bought a 36" piece of 3/8" PEX pipe. PEX is made from polyethylene and is pretty similar to nylon in hardness and low friction. I trimmed a 3/8" piece off and made one cut along the side. After submerging it in boiling water for a few minutes, I formed it around the 1/2" handle of the x-acto I used to cut it with. It snapped right on the contact lobe of the door latch. The door closes almost without effort now. 15 minutes for both doors and $1.60 in materials. No grinding.
    1 point
×
×
  • Create New...