Jump to content
HybridZ

Leaderboard

Popular Content

Showing content with the highest reputation on 03/20/20 in all areas

  1. Had to custom make a couple of offset interior door handles, as the stock ones would not clear the roll cage door bars. I knew this was going to be an issue, and initially planned to just use a couple of pull-cables to open the doors, but that introduced issues as well. Namely, the cable handles, unless very small, wanted to hang down and get caught when trying to close the doors. This was a bit more work, but hopefully a better long term solution. Basically they differ from stock only in moving the lever approximately two inches downward so they open freely below the door bars.
    1 point
  2. Wrong bolts (to small) between the driveshaft and hub could also clunk under load.
    1 point
  3. Thought I would drop a few pictures and an update here before starting a build thread and informational text/videos for others to reference. I have the engine ready for a clean up, inspected the cylinders which were pristine, and turned it by hand. Got all of the pieces together to send to ZFever for the wiring harness service. I’ll be posting about the adventure in finding the wiring parts soon.
    1 point
×
×
  • Create New...