-
Posts
93 -
Joined
-
Last visited
-
Days Won
1
Content Type
Profiles
Forums
Blogs
Events
Gallery
Downloads
Store
Everything posted by rk2334
-
with ps6266 you can run higher psi than stock turbo 12psi. I think its ok to run 24psi with limited rpm to 7k because of weak oiling system.
-
Fill and restore the cracked dashboard and interior parts also trying to replace broken ac with universal one. Closed all firewall holes; ac pipes, heater pipes and ecu harness hole, and made one hole for all from battery tray side. And battery moved to rear side
-
Replaced the old clutch master cylinder with new OEM Nissan patrol one and made flange to make it fit
-
Thanks for comments. I will make holes in shroud. There is a seal tape between shroud and rad to close the gap, also planning to install one 12inch slim puller fan.
-
-
-
-
-
-
-
-
Engine and trans out ,clean and paint the bay Fabricating custom oil pan with rear sump, -10 AN fitting Oil Port Fitting for External Oil Filter, Depth: 6" at sump, 1 5/8" front half of pan also oil pickup extended and modified.
-
Hey Forum I would like to share my swap bought 300z with 2jz but always overheated and I cant drive for long distance
-
Fabricating custom oil pan with rear sump, -10 AN fitting Oil Port Fitting for External Oil Filter, Depth: 6" at sump, 1 5/8" front half of pan, also oil pickup extended and modified.
-
-
Hey Forum I would like to share my swap bought 300z with 2jz but always overheated and I cant drive for long distance
-
Hi everyone, I have swapped rb20 into 280zx 1983turbo. The stock speedometer was straight forward mechanical outputs, but I don’t know how to modify stock tachometer to take a rb20 signal . Any advice is appreciated as always
-
Hi everyone, I have swapped rb20 into 280zx 1983turbo. The stock speedometer was straight forward mechanical outputs, but I don’t know how to modify stock tachometer to take a rb20 signal . Any advice is appreciated as always
-
I have upgraded my 240z brake booster with electrical vacuum pump, connected direct to brake booster, works great no issue
-
RB26 Front Sump Setup with Custom Crossmember
rk2334 replied to Kevlars30z's topic in Nissan RB Forum
I bought rb25 pan and modified it Check my building http://forums.hybridz.org/topic/123114-golden-rb-240z/?do=findComment&comment=1151028 -
RB26 Front Sump Setup with Custom Crossmember
rk2334 replied to Kevlars30z's topic in Nissan RB Forum
better to go with R33gts or s14 crossmember, approximately 2inch wider -
I think the best choice is lexus ls460 output 350amp