HybridS30 Posted May 25, 2011 Share Posted May 25, 2011 Starting up the project again and broke the Rod End that holds the shaft. Wonder if I can run it with just 2? Maybe now I don't have to shorten the linkage shaft? Any good place to find a replacement for the Rod End? Would this work? http://www.piercemanifolds.com/product_p/99006.540.htm Thanks! Quote Link to comment Share on other sites More sharing options...
Dingo240 Posted May 26, 2011 Share Posted May 26, 2011 Did the welding work? Quote Link to comment Share on other sites More sharing options...
HybridS30 Posted May 27, 2011 Author Share Posted May 27, 2011 Trying to go for the cable setup instead, but not sure if it will work with just two linkage rod holder from three. Quote Link to comment Share on other sites More sharing options...
josh817 Posted May 30, 2011 Share Posted May 30, 2011 It's a solid rod, the support should be there with just two. Can't tell from the picture on what you did but the only problem I can see is the linkage on the carb obviously can't connect with the shaft since it's pushed back. Just get some pliers or vice grips and unscrew that one, replace it with another. Don't know if it's metric or not. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.