Jump to content
HybridZ

1976 L28e Performance 1.0mm Headgasket


monster reem

Recommended Posts

Stock & Felpro are 1.0mm thick compressed. I've measured both during my engine rebuild.

 

You should not use gasket thickness as an option to bump the compression ratio. You should use your head, your block & pistons/rods for this.

 

I have machined the top of my pistons to match my setup: block resurfaced, milled P79 head & flat top pistons.

 

 

Edited by Lazeum
Link to comment
Share on other sites

Well I wanted to get the head gasket from z car motorsports but there performance gasket is 300 bucks so I was wondering if anyone had a one or two mm performance gasket cheaper. I have a rebuilt n42 head so I wouldn't bump compression up to much bc my head is alil under spec so it would put it back within its limit.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...