EDIS ? CHrysler coil wiring double check

[str8pipez]

After finding conflicting info I would to know if anyone can verify if I have the wiring from the EDIS module to the Chrysler coil pack connector.

 

I'm connecting as follows:

 

#10 EDIS pin (yell/blk) to coil pin #2 (gray/red)

#11 EDIS pin (yell/wht) to coil pin #4 (blue/gray)

#12 EDIS pin (yell/red) to coil pin #1(red/yell)

 

Green/orange from coil plug to 12+, coil pin #3

 

I have attached a photo of both plugs.

 

Thanks in advance.

[mattb3562]

Ive got the same setup in my car. Tonight I will look back at my schematics and let u know.

[str8pipez]

Thanks, greatly appreciate it!

[mattb3562]

Here's how I wired mine and it works great.

http://forums.hybridz.org/topic/56438-corrected-wiring-diagrams-for-edis-6-ignition-module/

 

Also, tie a wire into each driver signal and wire in diodes as shown in this pic for your tach signal. I removed the factory tach resistor and plugged my tach wire into the factory harness with a bullet connector.

Edited May 16, 2014 by mattb3562

[str8pipez]

If that is the case, you show EDIS pins 10, 11 and 12 going to pins 1, 2 and 3 on the coil plug, but the coil plug diagram shows #3 as ASD relay and pin #4 (which you show as 12+) as coil driver 2, not 12V as shown in your diagram. What am I missing?

Edited May 19, 2014 by str8pipez

[mattb3562]

Maybe this will be better