Jump to content
HybridZ

auto to manual trans swap newbie question


sorealsosurreal

Recommended Posts

is it as simple as swapping trans, flywheel, clutch, pedals, clutch master, slave cylinder, and lines,and cutting hole in floor board? will i need a different crossmember as well? going to look at what seems to be a great priced 1972 240Z tomorrow and its auto and that just wont do. any info on parts or tricks I'll need would be greatly appreciated. will all holes (threaded or not) that i will need be there besides the hole for the shifter? 

Link to comment
Share on other sites

That's pretty much it. You may not need to cut a hole, but rather trim out the front part of the hole for more shifter clearance.

I'm sure there are a few posts about this, I know I posted some details of my swap a few years ago, and I THINK I posted it on here. If I didn't, there are some general details in my build thread, or should be. 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...