FlameShadow Posted February 3, 2015 Share Posted February 3, 2015 Basic question is this possible in any sort of functioning configuration? Mounting issues. Thanks Quote Link to comment Share on other sites More sharing options...
NewZed Posted February 3, 2015 Share Posted February 3, 2015 Yes it is, Two wires to the VR, two wires to the coil, and a good ground circuit.. Not sure what you mean with the "mounting issues". A GM HEI module would be the same amount of work though. Quote Link to comment Share on other sites More sharing options...
FlameShadow Posted February 3, 2015 Author Share Posted February 3, 2015 I put mounting issues because the only results I could find about it talked about the mounting issues. Thanks Quote Link to comment Share on other sites More sharing options...
NewZed Posted February 3, 2015 Share Posted February 3, 2015 There are always mounting issues. There's a good thread on another forum by a guy who mounted an HEI module inside the box that the original 280Z module was in. All of the wires are already there and it's protected from the elements. You could do the same with the ZX module. Quote Link to comment Share on other sites More sharing options...
FlameShadow Posted February 3, 2015 Author Share Posted February 3, 2015 Awesome thanks a lot Quote Link to comment Share on other sites More sharing options...
FlameShadow Posted February 3, 2015 Author Share Posted February 3, 2015 Directions would be pretty well the same as installing a 280zx dizzy into a earlier z minus the actual distributor install correct? Just wanna be double sure before I do this. Quote Link to comment Share on other sites More sharing options...
NewZed Posted February 3, 2015 Share Posted February 3, 2015 Not quite. You'll be moving the module away from the distributor. For the ZX the two wires from the VR are connected internally, behind the module, where you don't see them. They're still red and green though. Just connect red to red and green to green and make sure that the module is grounded. Grounding of the module body is key, that's where the coil current goes. Quote Link to comment Share on other sites More sharing options...
FlameShadow Posted February 3, 2015 Author Share Posted February 3, 2015 Ok, I found that thread you where talking about so essential the only wires I would be using from the stock module location are the red and green ones the rest get capped off and tucked away if I am understanding this correctly and if I'm not I appogize lol Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.