Jump to content
HybridZ

aluminum distributor cap


Recommended Posts

Ok third try on this post.

 

But I had this cap made for my trigger wheel and CNP/COP setup. So I wanted to test the waters to see is anyone else would like to have these made. Seen them in the past for over 200 each I would have these made for around 150, would take a week or two to be made. Also would need the washer in the dizzy that the rotor attached to be machined down (shown in photo) I had this done for a lower profile.

 

As I said this is a test to see what kind of interest this would gather among the z guys. Thanks for looking.

post-12782-0-81747000-1432847584_thumb.jpg

post-12782-0-42472300-1432847615_thumb.jpg

post-12782-0-91318700-1432847651_thumb.jpg

Link to post
Share on other sites

When I first read "aluminum distributor cap" I thought, "well that isn't going to work very well..."

Then I see that it's for using DIS. LOL

Looks good, I like it.

Sorry, I don't have an L28 anymore, and when I did I ran a differnt style DIS, where I was able to eliminate the dizzy completely. Just wanted to comment on how good it looks.

Link to post
Share on other sites
  • 9 months later...
  • 1 year later...
  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...