Jump to content
HybridZ

SOLD - 1971 240Z Series 1 project, Western PA


mditt8671

Recommended Posts

Could you send whatever pictures you have on hand to Luke hanus @  yahoo . Com (no spaces). The pics in your blog won't load on the 3 devices I tried. I'm about 4.5 hours away from you, I've gone a lot further than that before for the right car.

Link to comment
Share on other sites

THIS IS NOT THE CURRENT STATE OF THE CAR. The car has been taken down in preparation to be sandblasted; front fenders, hood, engine grill, etc all removed. R180 rear is gone and have an R200 that goes with it, but it's not installed. Intent was to get it sandblasted and start reassembly. The floor pans are the worst part of it, but the rust doesn't go far and I have the Zedd floor pans to completely replace them (along with frame rails and everything else needed to make this new again). All parts from disassembly have been put in labeled ziploc bags, not just tossed in a coffee can or something.

 

ontrailer.jpg

IMG_20110703_085408-1024x768.jpg

ontrailer2.jpg

CameraZOOM-20130224115021709.jpg

SAM_0159.jpg

CameraZOOM-20111219150526324-Medium.jpg

CameraZOOM-20111219093259992-Medium.jpg

IMG_20110703_085408-940x198.jpg

CameraZOOM-20111216134029190-Medium.jpg

CameraZOOM-20111216134043103-Medium.jpg

CameraZOOM-20111216134111794-Medium.jpg

CameraZOOM-20111216134133996-Medium.jpg

CameraZOOM-20111216134346212-Medium.jpg

CameraZOOM-20111216134401543-Medium.jpg

CameraZOOM-20111216154559685-Medium.jpg

CameraZOOM-20111216154622941-Medium.jpg

CameraZOOM-20111216154637820-Medium.jpg

CameraZOOM-20111221142806864-Medium.jpg

CameraZOOM-20111221142818354-Medium.jpg

CameraZOOM-20111221142837398-Medium.jpg

CameraZOOM-20111221142845394-Medium.jpg

CameraZOOM-20130224115039295.jpg

Edited by mditt8671
Link to comment
Share on other sites

I don't have those pics right now but I can get them.

 

The original color was yellow... this has been repainted. They used a reddish primer under the paint.

 

I believe the left rear fender skin was replaced at some point; there is a cut inside the wheel well between the fender/wheel well that really needs to be connected for best structural integrity. I might have a pic of that; I'll try to find it.

 

 

ETA: found it

CameraZOOM-20130224105209498.jpg

Edited by mditt8671
Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...