Jump to content
HybridZ

Bee R rev limiter install on RB20DET


GabeDiaZ27

Recommended Posts

So I recently installed a Bee-R rev limiter on my rb20 and had a question. If you know how to install these there is 4 main wires to hook up. Power, Ground, and two others (one green and one yellow) for the signals. anyways I just cut these wires from the ecu and connected them directly to the bee r unit. so far everything has worked fine as far as I can tell. Recently though I have read not to cut these and connect them directly to the bee r but rather splice into or "Piggyback" onto them or at least onto the signal ones. Can anyone who has installed one of these please verify what I should do? I tried it both ways and couldent tell a difference, Thanks!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...