Jump to content
HybridZ

Tach adaptor/ step up resistor


Fairlineguy

Recommended Posts

Having messaged the guys at tach match and received the following reply have decided to go with one of there units.

Indeed you do have a current driven tachometer.  The TachMatch TM-02-I-Drive unit will operate your stock tachometer.
 
My understanding is that the RB25 has a tach output signal on pin 7, which is an open-collector output.  Being open-collector, it needs a pull-up resistor to get the signal operative.  I would recommend a 1.3k ohm pull-up resistor for use with the TachMatch.  If you wish, I could install one inside the unit for you at no extra charge.  I'm not sure about the maximum sink current on the RB25 pins, I've seen on the internet that folks use 1k resistors sometimes, so I'm presuming that this slightly higher value (1.3k) should be ok, it loads the pin less than 1k.  I can't find the actual spec anywhere for your ECU.
Link to comment
Share on other sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...