Jump to content
HybridZ

Turn Signal Leftovers (I am an idiot)


Recommended Posts

So I decided to completely tear down my 1978 280z turn signal switch. I cleaned and lubed every moving part and it is 1000x times better now. However I am left with one extra ball bearing. There are a total of 3 bearings. The two larger ones go on each end of the rocker part. The last one is significantly smaller and I have no idea where it is supposed to sit. I honestly don't even remember taking that bearing out.

 

Does anyone know where it belongs?

Link to comment
Share on other sites

5 hours ago, Miles said:

Look at the rocker inside the TS switch in the video.  See the center stalk that pushes the rockers? There should be a small ball bearing with a spring in the center stalk.

 

 

 

This is actually where the the 240z and 280z switches deviate the most. I've included a photo. I'm pretty confident the ball bearing does not go there. Has anyone seen a guide for the 280z switch?

IMG_20190422_213232.jpg

Edited by munkey_mike
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...