Jump to content
HybridZ

Ford EDIS6 wiring


Turbo-six

Recommended Posts

I am working to clean up some wiring on my car, it's an s30 with l28et swap and Ford edis, Chrysler coil pack etc. It was setup by a previous owner and ran quite nicely, but the wiring was a bit messy. 

 

I am trying to wire back the Ford edis, based on the wiring diagram common here, there is a resistor 25uf placed on the EDIS power supply that is grounded. My car has resistors wired in to the 3 coil supplies, circled in blue in the attached Pic. My assumption are these are serving the same purpose as the 25uf in the normal diagram? On my car, the ends are tied together and attached to a single blue wire that I would assume needs to be grounded. In my haste I cut this wire without documenting where it went. The power supply #4 on the plug in my car does not have a 25uf wired in like the diagram. 

 

The engine is controlled by ms2 3.57

 

Thanks for any guidance. 

20200124_125136.jpg

Edited by Turbo-six
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...