badjuju Posted February 20, 2008 Share Posted February 20, 2008 Thanks a ton! I think what I'll end up doing is either gnawing off a tooth off the 24 tooth wheel, or just using the two trigger setup. I literally just[/] sold a full edis-6 setup, so I don't really want to go around hunting all those parts again, plus I think if you run edis you can't run launch control or a soft rev limiter. Quote Link to comment Share on other sites More sharing options...
Clifton Posted February 20, 2008 Share Posted February 20, 2008 plus I think if you run edis you can't run launch control or a soft rev limiter. You are correct, no launch control w edis. If you have MS control 3 coils you need to add two more drivers but it isn't too hard. Quote Link to comment Share on other sites More sharing options...
badjuju Posted February 21, 2008 Share Posted February 21, 2008 yeah i figure i'll do it as i build the rest of the ecu. Quote Link to comment Share on other sites More sharing options...
badjuju Posted July 17, 2009 Share Posted July 17, 2009 Just an update, wow it's been a long time since I've moved on this project. I have a VEMS box headed to me as we speak, and there is a brand new wiring harness all laid out and waiting for me to start connecting stuff. Quote Link to comment Share on other sites More sharing options...
yhlz Posted July 18, 2009 Share Posted July 18, 2009 did you already hook up the clutch slave and master cylinder? how was that? Quote Link to comment Share on other sites More sharing options...
badjuju Posted July 19, 2009 Share Posted July 19, 2009 haven't done it yet, haven't even built my motor mounts yet. However, I'm about to move into a place with a four car garage, so the motor mounts should be done in about two weeks Quote Link to comment Share on other sites More sharing options...
yhlz Posted July 20, 2009 Share Posted July 20, 2009 damn, i'll be in seattle in a week or so too. i wish i could see that z of yours since i'm in the process of the same swap. Quote Link to comment Share on other sites More sharing options...
XTCoX Posted January 30, 2010 Share Posted January 30, 2010 Badjuju, when you say "new wiring harness", you are talking about a prefab harness that hooks up the VEMS box to the 7M's stock sensors and electronics, right? Quote Link to comment Share on other sites More sharing options...
badjuju Posted February 23, 2010 Share Posted February 23, 2010 some months later, I get back to the boards... lol Both. I have all but finished a painless harness for the entire car, and about 80% done with the VEMS harness. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.