mr jdm Posted December 5, 2010 Share Posted December 5, 2010 So, finally started her today. The haltech e8 is the first standalone I have ever used. I wired up the entire car from scratch and let me tell you. I never would have expected everything to be so EASY when you understand wiring and can spend a good two hours studying the haltech manual. She started first try, Quote Link to comment Share on other sites More sharing options...
lowrider Posted December 5, 2010 Share Posted December 5, 2010 Hey, I met you on the dragon a few months back. The car sounds mean! It looks extremely clean, nice job! Quote Link to comment Share on other sites More sharing options...
BLOZ UP Posted December 6, 2010 Share Posted December 6, 2010 Looks great, sounds great. But it's missing 2 cylinders... Just kidding. Mods? Quote Link to comment Share on other sites More sharing options...
mr jdm Posted December 6, 2010 Author Share Posted December 6, 2010 (edited) Hey, I met you on the dragon a few months back. The car sounds mean! It looks extremely clean, nice job! Yea whats going on, I spent some time looking for you on her but had no luck. Il be at the dragon 3 times this summer twice with bike and maybe once with the car. Here are the engine mods only Haltech E8 72 lb injectors JWT Rail AFR Walbro 255 Arp Studs Cometic HG BC 272 12.5mm lift cams BC Valves, springs, and retainers Peak Boost Equal Length Tial 38mm Sc61 76 trim .82 a/r 3" Side Exit exhaust Profec E01 JGy 9lb Flywheel UR Pullies Modfied Ebay Intake Manifold 100mm Throttle Body Summit Fuel Cell -8 SS Braided Lines entire system Griffin Radiator FMIC Il add spitfire coils if I think Il need them on the dyno. Edited December 6, 2010 by mr jdm Quote Link to comment Share on other sites More sharing options...
piston Posted December 11, 2010 Share Posted December 11, 2010 Damn, that is a pretty sick looking setup you got there. Nice and clean...Not to familiar with sr20's but is .82a/r exhaust a bit on the lagg side for the sr? 1jz will take some time to spool that sucker. Quote Link to comment Share on other sites More sharing options...
mr jdm Posted December 13, 2010 Author Share Posted December 13, 2010 Damn, that is a pretty sick looking setup you got there. Nice and clean...Not to familiar with sr20's but is .82a/r exhaust a bit on the lagg side for the sr? 1jz will take some time to spool that sucker. I dont think the lag will be to bad, a lot of smaller motors running gt4088's out there. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.