[TVR speed six engine]

Hi I`m renovating the house so I cant start working on the swap before ca one mont (wife wold kill me if I dont finich the house project before I start working on the car)

I wil post fotos on the proses.

I have done some mesuring and it wil be a thight fit in the hight.(may have to make a new fuel rail and lower the stearing rack ca 10mm.)

 

Regards

Rune K

[Change tailhouse on a T5 WC]

Hi what are my options on relocating the shifter.

dose a tailhouse from a NWC fit on a WC (same axle dimentions?)

Is there a shifter relocator kit that i dont need to change the tailhouse.

Im working on a 240Z TVR Speed six engine swap.

[TVR speed six engine]

Engine have arrived (took some time doe to union strike at the shipping terminal)

 

Engine Hight is 61cm (24") at the higest point.

[TVR speed six engine]

Hi I`m not so god in grammar so please bear whit me.

I`t also uses BW T5 gearbox so I hope this wold make the swap easier.

 

A nice soundklipp from youtube

[TVR speed six engine]

Hi I just ordered a TVR Speed six engine to make my hybrid 240Z

 

Engine spec

4.0L N/A 385hp 310 lb·ft 24 Valves Drysump and ivt

 

I think this engine is gone be nice in my Z decat and chip 400hp n/a

 

Enybody seen a convention like this before ?

 

Regards

Rune K

Norway

[Complete L6 engine max 7500,-]

Please send foto and spec to rkvaerno@online.no

 

(I wasent able to send you a mail datsundriver88@hotmail.com' Somting wrong whit my outpost innbox is fine

?????

[Complete L6 engine max 7500,-]

Hi I whant a built engine I wold prefere a NA engine but turbo can also be interesting. prise max around 7500,-

I live in Norway but i have shippingadres in US NJ (jetcarrier.com) paypal confermed adress.

I can pay whit paypal or visa (you shipp after payment are confirmed)

I Will not by a engine from a new member and end op whit a non existing engine lol.(ore you can have a trusted memper to verify fore you )

 

Regards

Rune K

[Building a stroker N/A budget 5K]

HI I`m building a stroker and I need help to deside on what parts to use $ on.

I whas at the salvage yard today and pulled an LD28 crank (steal 150$ ?)

goal is 230-250 whp.

 

Head work (ink head) 2k ? (what builder wold you use)

Block including boring $ ?

forged pistons (is it needed) 700$ or KA24

Forged rods (is it needed) 700$ or L24 9mm

Balansing of crank $ ?

Header (any recommendations)

Balanser

efi (MS edis) 600$

Camshaft 500$ ? (recommendations)

Bearings, waterpump,++++ 1k

 

Or just look fore a used tuned NA engine.

 

This is my first post on this forum (I have been reading fore years, thanks fore all the knowhow on this forum)

 

Regards

Rune K

Norway