Search the Community
Showing results for tags 'push button starting'.
Found 1 result
-
I am stumped on this! I have a Longacre switch panel toggle switch/pushbutton start and Longacre Heavy duty wiring harness with these instructions: Brown wire – to battery or power source (you can pick up power at the starter motor). The larger ring terminal goes to the battery cable terminal. Two Yellow wires – one wire to ignition system; one wire to any accessory you want to shut off with the ignition – gauge and warning lights, tach, etc. (NOTE: Both yellow wires are connected to the same source. Two separate wires are provided for your convenience.) Green wire – to your starter solenoid. The smaller ring terminal goes to the solenoid. From the Speartech harness and instructions the LS1 orange wire is connected to the battery. We connected the LS1 pink wire to one of the Longacre yellow wires for ignition crank and run. We flipped the toggle switch that is the other yellow wire on Longacre panel connected to fuse panel and the LS1 diagnostic port lights up and fuel pump kicks in. I hit the pushbutton and it fires right up! Problem!! The toggled switch does not turn car off. I have to disconnect the battery to turn off engine. If you have toggle switches/ pushbutton starting what I am doing wrong? Let me add the car has been re-wired with a Kwik Wire 8 Circuit hot rod harness. By the way get this straightened out, bleed the brakes and bodywork/paint finally done !!
