280z4me2 Posted September 22, 2011 Share Posted September 22, 2011 I am shaving/repairing the rear of my 280z by welding in a 240z rear panel. After measurements were taken, I realized that the last Guy welded everything in the wrong place. What I need is a measurement from under the car, from something in a fixed position (back of diff cover...) to the bottem of the rear roll pan. So I will know how far the bottem of the panel curves in. Also, a side shot of the car. The rear section that curves from the back of the rear fender lip to the roll pan. It slants up to the bottem of the roll pan. I need a measurement from the ground to the bottem of the lowest part. And another measurement from the ground to the bottem of the roll pan. I know this is hard without pictures but I'm sure some of you guys understand what I'm saying. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.