Challenger Posted January 1, 2012 Share Posted January 1, 2012 (edited) Just hooked up my MS tonight for the first time! Learning a lot as I go through and look at all the settings. Heres the question, I am in Ignition Options and am setting up the general ignition settings. Under "Spark Mode" I am allowed to choose EDIS or EDIS multispark. Which am I wanting? I am using the standard setup for EDIS-6. I have been searching the megamanual, hybridz and the web but cant find which one I need. Also, I have the trigger wheel set up to have the missing tooth 60 degrees clockwise from the VR sensor when looking from the front of the engine. From what I understand If I set the Trigger Angle/Offset(deg) to 60 (+ or -, not sure which one, is it -60 because its before TDC?) that should put it very close. After that Ill just need to adjust the trigger wheel itself or the offset with the aid of a timing light? Ignition input capture = rising edge and spark output = "going high (inverted)" Correct? Thanks! Edited January 1, 2012 by Challenger Quote Link to comment Share on other sites More sharing options...
letitsnow Posted January 1, 2012 Share Posted January 1, 2012 It's been a while since I looked at EDIS stuff, but I think either should do. I believe multispark just sends several sparks below a certain rpm, kind of like an MSD box. Try searching msextra.com, that's where you really need to look if you can't find an answer in the manual. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.