zspeed22 Posted December 14, 2015 Share Posted December 14, 2015 Hello all. I plan on using these for my turbo setup they have a nice tight design and I have seen them used many times with Vbands welded onto them. Just thought I would share with everyone. https://holley.com/products/exhaust/headers_and_exhaust_manifolds/exhaust_manifolds/parts/8501HKR Quote Link to comment Share on other sites More sharing options...
Mikey303LSZ Posted December 18, 2015 Share Posted December 18, 2015 Nice - I was looking hard at those too. Decided to go with OEM truck manifolds to save $. Picked these up for $50 on Craigslist. Plan is to go down and forward on my turbo setup (240Z LS1). Quote Link to comment Share on other sites More sharing options...
Meatwad Posted December 19, 2015 Share Posted December 19, 2015 I was thinking about using them, but didn't want to possibly wastd some cash. Decided to just make manifolds for my application Quote Link to comment Share on other sites More sharing options...
zspeed22 Posted December 21, 2015 Author Share Posted December 21, 2015 So these are tight enough to fit into the frame rails but run right into the engine mounts. I was lucky enough to barrow these for test fitting. I think I will be going custom made as well. Quote Link to comment Share on other sites More sharing options...
Mikey303LSZ Posted January 6, 2016 Share Posted January 6, 2016 Zspeed - do you have pictures of the test fit? Quote Link to comment Share on other sites More sharing options...
zspeed22 Posted January 6, 2016 Author Share Posted January 6, 2016 Sadly no I do not, If you wanted to cut and weld V-bands, close to the first runner along with possibly filling in some gaps, they would work just fine because they do hug the block nicely. I just decided to go a different route then cutting them. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.