Guest turbotier01 Posted May 12, 2008 Share Posted May 12, 2008 hey guy's thought i'd share my progress with this forum, i'm building a twin turbo 2001 frontier with twin precision dual ball bearing turbo's, in the shop now getting a halltech stand alone now with 780 domestic injectors with custom fuel rail's, truck was dynoed at 340 rwhp before it went back for the halltech, problem was stock mass air could not read fuel and increased air level's so i'm excited to see new result's, will share dyno vid next week.. Quote Link to comment Share on other sites More sharing options...
Guest turbotier01 Posted May 26, 2008 Share Posted May 26, 2008 entire job complete, but upon initial test of halltech lost signal from distributor trouble shooting now getting impatient, will keep updating:fmad: Quote Link to comment Share on other sites More sharing options...
Guest turbotier01 Posted June 6, 2008 Share Posted June 6, 2008 update, halltech was shipped back to factory for dianosis, found ignition function to be burnt up unit was replaced by halltech since they provided wiring shcematic will be back in there hand's friday the 6th keeping finger's crossed! Quote Link to comment Share on other sites More sharing options...
Guest turbotier01 Posted June 16, 2008 Share Posted June 16, 2008 haltech came back, rewired motor according to the wiring specialist at haltech, motor still did not start. after viewing 87hybird's 300 z saw where he is using coil pack's from gm and a trigger switch on the crank result's still pending :fmad: Quote Link to comment Share on other sites More sharing options...
Guest turbotier01 Posted August 9, 2008 Share Posted August 9, 2008 my truck finally fired up today, what a good feeling all this wait for parts, 2 wk wait for machine shop 4 wk wait for ati pulley there is now nissan 4 trigger wheel because of all the reseach halltech did on my 3.3 ignition might have dyno results monday or tuesday :p:p Quote Link to comment Share on other sites More sharing options...
Guest turbotier01 Posted August 19, 2008 Share Posted August 19, 2008 :grin: truck was started a couple day's ago, all's well so far 1st dyno pull today 350 rwhp 360 tq some more tuning tomorrow :lol: excited to drive it after almost 5 mths... Quote Link to comment Share on other sites More sharing options...
Guest turbotier01 Posted August 30, 2008 Share Posted August 30, 2008 truck is complete, finally iv'e been driving it the last two knights cold start is a bitch but once it warms up it's like final tune was set at 16.5 lbs of boost and layed down 371 hp and 386 torque on 93. will post some pic's on streetfire! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.