will these fittings be okay for aluminum fuel line?

[inlawZ]

so i'm going to be installing new aluminum fuel line for my 240z l28et swap. i will be using 1/2" or 3/8" aluminum hose and was wondering which fittings i should use without having to mess with the tank. i will be installing a surge tank as well, so will these fittings work?

http://www.anplumbing.com/shop/index.php?shop=&dept=Super!_Stock!_Hose!_Ends

 

the ones on top of the page 00/00 under the image. is it okay to clamp rather than use AN fittings? this is for a daily driver .

 

this is how i am hopefully going to set this up:

 

tank -> filter -> surge tank -> efi pump -> filter -> aluminum line -> fuel rail

[TimZ]

so i'm going to be installing new aluminum fuel line for my 240z l28et swap. i will be using 1/2" or 3/8" aluminum hose and was wondering which fittings i should use without having to mess with the tank. i will be installing a surge tank as well, so will these fittings work?

http://www.anplumbing.com/shop/index.php?shop=&dept=Super!_Stock!_Hose!_Ends

 

the ones on top of the page 00/00 under the image. is it okay to clamp rather than use AN fittings? this is for a daily driver .

 

this is how i am hopefully going to set this up:

 

tank -> filter -> surge tank -> efi pump -> filter -> aluminum line -> fuel rail

 

I'm assuming that you are looking for proper ends for aluminum fuel line? If so, the ends you listed will not work - those are for socketless hose, not aluminum lines.

 

To do aluminum ends, look for "tube nuts" and "tube sleeves" - you will need both, plus a flaring tool.

 

If this is for the low pressure side and you aren't planning on running E85, I think Russel's makes a compression fitting adapter (the compression ring is brass, which doesn't like alcohol)