Jump to content
HybridZ

Individual throttle plates for 5.0 design


Recommended Posts

I drew this up and was quite proud of it. I based it on the lower half of the Cobra intake. Basically I was thinking of having this on top of the lower intake. I was thinking of it being milled out of two peices of aluminum that sandwich the plate assemblies inside and also a spot made to keep the 1:1 gears from getting dirty and jamming. Which also give a spot to mount the TPS. One thing I didn't think about was an IAC. Do you all like it?

13786_thumb.attach

Link to comment
Share on other sites

Speed density. I figure with speed density it would be easier to tune for a boosted application. Or maybe you could just use the MAF on the inlet of the upper intake, that would work, right? Also note, the throttle pulley would be in interference with distrubitor.

Link to comment
Share on other sites

Did more drawing. The upper intake design idea was inspired by 1artworkz's and Monzster's designs here http://forums.hybridz.org/showthread.php?t=144523&highlight=audi+intake and here http://forums.hybridz.org/showthread.php?t=127863&highlight=audi+plenum The weight figures are taken from Dart's product specs but the Total line are estimated.

13831_thumb.attach

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...