Jump to content
HybridZ

dawg7

Members
  • Posts

    20
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location
    TX

dawg7's Achievements

Newbie

Newbie (1/14)

0

Reputation

  1. I just installed a set of Z Therapy SU carbs and decided to go with a cold air intake setup. I didn't have any air filter pieces and Bruce from Z Therapy recommended trying a CAI setup. So I bought the air box from Unique Z products (99$) and the Spectre 3 inch chrome covered plastic piping with filter (80$) from O Reilly parts. Very tight fit going thru the 3 inch hole near the radiator. Should have opened that hole up a bit and not scratched one of the pipes. I plan on moving the horn to the other side and rigging up a standoff clamp to go around the pipe.
  2. I need one carb top for my -18. One of the float pin supports is broken. I'll take the whole carb.
  3. No problem....got a line on a set.
  4. I am building a L28 stroker and need the rods. FYI, Courtesy NIssan has 5 rods left at 88$ per; MSA has rods for 105$ each; CX racing rods for 58$ each and there are others that are close to 1000$ a set. I don't see a problem using 40 year old rods and staying around 10.5 :1 compression. I don't have much to trade...I do have a stock clutch setup and some round top SUs.
  5. A pic of the underneath with clips. Note that two clips have bolts and the other two are slip on.
  6. I can't check it on my Z because it already has a spoiler. And there isn't many Z's in my part of Texas. There are four clips that attach at the bottom four corners. Is that all that holds it on? I would want the hatch lock button to secure the middle...somehow, something in the middle.
  7. I got this EVA whale tail and I am wondering if the bottom of the piece is suppossed to have the slight bow upwards? It sure seems to be a symmetrical; as if it was designed that way. If it passes the judging from you fine folks I will put it up for sale....I already have a spoiler. Thanks for your opinions!!! I got this from a gentleman who had a 71 240z. It is approx 43 inches long across the mounting surface. I am thinking it will fit on the 240-280's. I don't know anything about EVA and when I googled EVA whale tail all I got was results of Ms Longoria; which was confusing since she doesn't have a whale tail!!!!!
  8. Thanks for the JDM link. Beats the heck out of Z specialities at 119.00 and 23.00 dollars shipping!
  9. I am looking for the heater tube junction. It is the junction located at the firewall between the heat control valve and the heater hoses from the engine block.
  10. oh crap.....not another piece that needs attention. Didn't notice that one. Thanks for pointing that one out.
  11. The PO did that years ago. Also it looks like some kind of Rhino Liner type spray on the metal/frame. It does look real nice under there!
  12. This is where I put the jackstands for replacing struts, springs and most of the bushings. The rear stands are real close to the stab bar but it clears it barely. Used a floor jack at the rear diff and front cross member. Very Stable. Got in the back hatch and also had it started.
  13. I need the wire harness that goes from the headlight connector (3 prong flat) to the three prong connector (round). 2 each. thanks
×
×
  • Create New...