[Lt1 does not run looking for help]

The VATS was removed from the PCM, however the by pass module that comes with the painless harness is wired.

Thanks Mark!

[Lt1 does not run looking for help]

I have constant 12v ignition while cranking, can a ignition module be faulty even when it checks out ok? Does any body know the right voltage parameters to the ignition module?

[Lt1 does not run looking for help]

Yes, I checked it according to some schematic I got online but I might have not done it right. I'll check it again. Thanks!

[Lt1 does not run looking for help]

Hi everyone, I'm new here looking for help.

For the last 10 years I've been working on this project and finally installed the engine and transmission. Used a painless wiring kit for the application, and reprogrammed the PCM to eliminate unnecessary components, tested opti spark and injector pulse and all checks out but I still have no spark.

I left it alone for about 6 months out of frustration but I think I'm ready to jump back on the saddle and burn some rubber before the end of the year.

Can anybody help?

Thank you all in advance