aircobra

super helpful, thank you luckily I only need replace about a 3rd of it, under the battery area ( its a RHD var), where the battery acid had got to you and it had a shunt at some point in time you can see it here https://photos.app.goo.gl/RXs2n6Hb6L7dRYRM7 and this view https://photos.app.goo.gl/LFhiBtxB9jTCcckn8 #1 step i get, #2. i was going to do the following a. take off the top reinforcement completely to expose the welds b. take off the rail and the wheel house c. then chop out a section of the f.wall and replace it with this FIREWALL REPAIR SECTION FULL HEIGHT RHD (BEHIND BATTERY TRAY) DATSUN240Z – KF Vintage d. then weldon the wheelhouse followed by the top reinforcement have i got it right?

Looking to do the same as this guy what do i need to remove and in what order i can see he has taken the outer reinforcement off at some point

yes on both

thank you

looking for either the low-offset or high-offset set of bubbles and the fittings thank you

I need to have a couple of complex panels fabricated eg a pillars, roof support, inner rockers, etc These are realy ahrd to make as they're multi layer and have 2d curves in them It will need a guy with the full set of gear and access to original panels and or templates I'm located in Australia, but am preapred to have them shipped Otherwise if you have mint panels, send me pics and prices Thanks