[3.5"]

Thanks just figuring out my options, its getting close to time for the swap!

[280zxt HKS Intercooler]

I was wondering about the efficiency of the HLS FMIC kit fot the 280zxt. My dad just installed one on his '83 and it is rather small compaired to the fabed up kits i see on here. Is anyone running this set up, if si what kind of boost are they able to run(i know that also depends on other factors). Any input would be great.

 

Thanks:-)

Kyle

[Forged?]

Thanks !

[3.5"]

Would a 3.5 inch exhaust in a 280zxt be worth it, OR, would it even fit?

[Forged?]

I want to try to get 350whp out of my 280zxt. I was planing to rebuild the whole thing soon and was wondering if forged is worth it for these numbers. I have herd of ppl getting that much on stock internals...but is that safe? it has to degrade reliability. Any input would be gerat.

 

Thanks,

Kyle

[Vacuum Lines in dash.]

Yeah i hve removed many dashes i just wasent sure if i had to take it out to get the the lines. Thanks anyway

[HKS SSQV does it have the partial throttle problem?]

Do to the way the SSQBOV is designed (Pull instead of push) It is impossible for it to leak at any psi of boost!

[Vacuum Lines in dash.]

To replace the vacuum lines in the dash, do i need to remove it, or is there a way to get to them w/o removing it? My car has a rough idle (when cold, and little less when warm). I have replaced all other vacuume lines under the hood and retimed it to stock timing. Any other ideas would be very helpful.

 

Thanks,

Kyle

[Forged or not forged? That is the question.]

I want to reach about 350rwhp in my 82zxt. Just wondering if it is worth it to buy a forged rebuild kit or just stock? Also who makes a good cam for a turbo engine? I've herd the turbo engines are very sensitive to cams.

[Stock Internals]

I was wondering what HP numbers i could expect out of the stock internals on a turbo motor w/o upgrading turbo, or internals. Fuel system mods and other ext. mods are ok.

[this is my plan]

Couldent remove post

[topend Performance?]

Thanks alot

[topend Performance?]

Anyone delt with TEP? I am going to rebuild my 280zxt engine and they sell a kit wit JE pistons new cam(any grind) valves, conn rods, and all the other good stuff? $1,800. any one else know of any other places that will sell a rebuild kit, wit forged internals?

[240sx Throttle body MAF --> TB tube]

I was wondering what tube you guies uesed from the mass air unit to the throttle body. The stock tube will diffently not fit.