Search the Community
Showing results for tags 'EZ Wiring'.
Found 2 results
-
Hi all, So I recently bought a toggle panel/push button start combo (here's the link: https://www.amazon.com/gp/product/B01JYRFLHG/ref=oh_aui_detailpage_o00_s00?ie=UTF8&psc=1). Pretty good build quality for the price, but I am rather uneducated when it comes to wiring. My goal is to be able to flip the first red switch and have that be my ACC power switch, then push the start button and off I go. I ripped out the old harness entirely and have rewired the car with an EZ wiring 21 circuit kit. Currently, It's getting power to the button but it's not cranking over anything. Also, when I turn the ACC switch the power goes through to the button, but even when I turn off the switch the current continues to flow through, I'm assuming the relay is set up incorrectly. After having that problem I did some research and drew up this diagram of what I think would be what I want, but in the diagram, I have the ACC toggle on its own, whereas I want it to be in line with the power to the button if possible. The Toggles are 3 prong units, so I think it's possible? I am hoping somebody can look this over and give me some practical advice and tell me if I'm close, and if not, what I need to change up! Thanks in advance. Here are the photos/
-
Hello my fellow Datsuneers, I am trying to plug in my EZ wiring harness to the ignition switch in my Datsun 240z. The problem is, I don't know what wire should go to the resistor tab. Any clarifications on what wires go to what specific contact point on the back of the switch? Telling me the wire colors is not going to help as I have no original wires from the Datsun left. Just the 5 prongs on the back of the switch that I need to connect the EZ wiring harness to. Any help?
