Search the Community
Showing results for tags 'Por15'.
Found 1 result
-
My z is an incomplete project my friend started, since the car is torn down as far as it is I'm going to go a little deeper than he did. My friend dealt with the rust on this car with a wire wheel and Por15, the entire interior floor, engine bay and front wheel wells. I want to cut out and repair a few areas of rust, stitch weld, complete the frame rails to the rear and roll cage. I'm wondering what I can do to get rid of the por15. -soda blasting - looks like eastwood has a 100# blaster, and from what I read the 80/20 mix says it will "The soda media will remove urethane, epoxies, enamels and lacquer top coats along with virtually every primer and filler for automotive and marine use" - media blast - What media is best? How can I keep from warping the metal? -Wire wheel - I don't think I can get into every nook and cranny. -Por15 remover - terrible stuff I hear, can I throw the used chemicals in the trash when I've stripped the por15? Thanks in advance for your help!
