Search the Community
Showing results for tags 'baffles'.
Found 1 result
-
Im finally getting around to building my 240z's gas tank. I will be installing the hyper fuel tight fit in tank retrofit kit with 525 lph pump to eventually power e85 on for my rb26 as well as a speed hut fuel float sender. Now that I have the tank cut open I'd like to weld in some baffles. After searching around online there are a lot of different methods being used, Iv came up with a few of my own and would like to get some feedback on them before going ahead if possible. Right around the pickup Im thinking about a maze like this and surrounding the maze im thinking the larger sized baffles to help with acceleration and braking as well as one to separate the larger chamber area from the thin area and potentially one more inside of the thin area. I will leave enough room on the side of the baffle for the float sensor. Im also planning to use the Por15 fuel tank sealer kit as its a bit rusty inside. Ironically if the baffles work too well it will make evenly coating it very difficult!
.jpeg.48aebc0652e715c744f92bd07018d569.jpeg)
