Search the Community
Showing results for tags 'cx-racing'.
Found 1 result
-
Just to forewarn anyone out there that is tempted by CXracing's "deals". I will share my recent experience with this worthless excuse of a company. First off, I will start with a bit of my backround in the automotive world... I have been building custom cars and motorcycles for over 25 years. I am far from new to the fabricating/aftermarket performance scene. I have a lot of experience buying and selling performance parts. I even ran a shop for a few years where I was in charge of ordering from and setting up accounts with aftermarket vendors. My 260Z is my baby and sometimes, when money is short but the desire is there, I have gone cheap but not without doing a little research first. I checked out CXracing and even bought a surge tank and an intercooler from them to check their quality. I have heard that all they sell is Chinese garbage and until my most recent purchase, I didn't have any complaints. I've owned my 260z for 15 years and I have done a great deal of custom work and upgrades to her. I performed my RB25DET swap over a year ago and I have been daily driving it ever since. I was a little disappointed by the dyno results so I decided to shoot for more HP. I ordered CXracing's RB25DET S30 turbo kit minus the mounts/intercooler since my car was already set up and I requested to swap the GT35 for their GT3071R. This is what I should have received... GT3071r ball bearing turbo with oil feed/drain lines, oil fittings, coolant fittings, 4 bolt to v-band adapter, manifold w/welded wastegate flange, 3" downpipe, and a 38mm wastegate. What I received was a GT3071r turbo with severe shaft play (the wheel hits the compressor housing), 24" feed line that won't fit unless it is routed in between and resting on the header tubes, incorrect oil feed and drain fittings (They sent me gt35 fittings not the gt3071r), the drain hose was correct but it's hard to screw that up, no coolant fittings/lines at all, no 4 bolt to v-band adapter, no wastegate flange welded to the manifold, 3" downpipe that wasn't even close to fitting (if my engine was 9" lower and 5" more towards the radiator it would work but that's impossible) and a 38mm wastegate that was so large the v-band clamp at the back of the turbo hits the vacuum port on the wastegate (after I had the flange welded on, of course). From what I have witnessed, the quality control department over at CXRacing doesn't exist and obviously the knowledge of what they are selling is lacking as well. If someone would have taken an extra 30 seconds to check what was going with what for my application, I wouldn't be writing this. Actually, if someone would have contacted me back after I left multiple messages (weeks ago) regarding these issues, I wouldn't have wrote this. The day I received the package I left messages with their sales department, tech department, my sales person and Kevin (I was told he was the man in charge) with absolutely no response from anyone. The guys at CXracing will answer all of your questions and help you any way they can until you pay them. Once they get your money, you can say goodbye to any service. Basically, they will take your money and send you some parts that might or might not work on your car. What doesn't work or was left out of the box, you are responsible for replacing. They do not stand behind what they sell unless there is a possibility of negative feedback on Ebay and that will only last until the feedback window is closed. I learned the "you get what you pay for" lesson years and years ago. I decided to give them a shot because of a recommendation from someone I know. Of course, they only bought an intercooler. I am hoping that no one else here or anywhere else makes the mistake of buying from this company.
