Search the Community
Showing results for tags 'megasuirt'.
Found 1 result
-
I have a 1977 280z with a L28ET swap. I'm running MS1 V3 with a Relay Board I bought the car running but for some reason after I uploaded a new firmware it stopped. I realized I didn't unplug the coil which probably fried it. At that point I decided that I would redo the horrible and complicated wiring that the previous owner did in the car. I bought a MS Relay Board and the wiring kit as well as I switched out the NA dizzy to a 1983 Turbo Dizzy. I wired everything up and redid everything and the car is cranking but not getting spark. So I did some test to see why it doesnt work and where is the problem coming from. 1. I checked if im getting spark at the distributor...Im not 2.I checked if Im getting spark at the coil... Im not 3. I checked if I'm getting 12v+ to the + coil and I was 4. I replaced the coil with a 12v light bulb to see if while cranking it would light up... it didnt 5. I checked if the relay board is getting 12v+ switched while cranking...and it wasnt so i temporary jumped the 12v+ from the battery (does this mean that my ignition is bad?) I figured the problem must be within the Megasuirt itself. So my questions are: 1.Is there any way to check if the pin 36/s5 output actually works? 2. Is there any way to check if the coil ignition chip in MS is dead? 3. Is it possible that MS is not sending signal to pin 36 because i wired my Turbo dizzy wrong...any way to check that? Below I attached a picture of a diagram of how I connected the coil. PLEASE help me I need this car running since it's going to be my daily and I'm tires of borrowing my friends car. THANKS IN ADVANCE
