Search the Community
Showing results for tags 'tc rod'.
Found 2 results
Compression rod Ball end Mod. using a mono ball from a Ford IRS. Turn down the TC Rod to 14MM (.551") cut to about 7", thread 14 x 1.5 MM for 2.75" The threading die was purchased from a machine shop supply for $11 the Mono balls from a self serve junk yard for $7 each. This is a simple bolt in BUT the pivot of the mono ball is about one inch forward of the factory. It has a smaller OD than the factory. I am a long way from a finished project, so testing will have to wait. If some one has run with a shortened TC Rod please let us know how it worked.
Selling 2 new Nissan OEM rear cross member bushings for S130/280ZX because I went another route. Purchased new from Courtesy Nissan Parts for about $30 each. Asking $45 shipped for both. SOLD: Selling 2 Moog and 2 Prothane TC Rod bushings. I know some people are worried about snapping the TC Rod. Some go with half and half (put the urethane up front where most of the load is) that is what I am doing on my 810 so now the other half is for sale. I have about $40 into both kits. Asking $15 shipped. 1979 810 Calipers, worked when I pulled the off about 7 years ago could be rebuilt or used as cores. Cover shipping as they are heavy and you can have them. Front caliper bridge pipes off my 810, can be cleaned and re zinc plated new. Make an offer.