John Scott Posted September 20, 2001 Share Posted September 20, 2001 I notice there is no mention of the 70% intake 100% exhaust CNC machining of the ports in the 195 heads. Not until you get into the 210 race ready do you see this. For those of you that have these heads, to what extent are the ports and chambers finished? I just found a used set of 195 angle plug Wrong CC for flat tops as well. I'm seriously considering ordering the bare models. These have the guides and seats installed. If anyone is planning on running more than 550 lift the spring and valve upgrade is another $175 putting the heads upward of $1400. If you have a good head person, the bare models might be a good option. JS Quote Link to comment Share on other sites More sharing options...
Guest RON JONES Posted September 21, 2001 Share Posted September 21, 2001 Thanks Bud Quote Link to comment Share on other sites More sharing options...
Guest RON JONES Posted September 21, 2001 Share Posted September 21, 2001 John Scott,Who is John Scott ?Long time ago there was a Guy on this Board named John Scott,could this Be the same Guy ? Hows it going John? Quote Link to comment Share on other sites More sharing options...
John Scott Posted September 21, 2001 Author Share Posted September 21, 2001 Doin' well Ron! Amazing what a little slow down at work allows! By the way, good luck next week at the bracket finals! JS [ September 20, 2001: Message edited by: John Scott ] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.