daveshybridz Posted June 4, 2003 Share Posted June 4, 2003 this is my first post. been reading alot since june 2002 and just got my driveshaft made yesterday and im readty to put it in. i have a 77z with 350/350TH JTR book and kit and the engine and trans is in. need some measurements to get me close to where i need to be. transmission is still under the jack, no spacers between frame and body(petes page),and i dont have any spacers between trans and mount yet, and i went ahead and took out the top washer on mustache bar and didnt cut the pin yet . should my driveshaft be strait or off set in the tunnel?, how many inches is the edge of the transmission mount( JTR) from the z frame rail on say the passenger side? my dist is less than 1/2" from fire wall my driveshaft is 22.5" its been a bitch so far, i met V8440 member here, about a year ago and he got me hooked. he lives 3 miles down the road and i got to ride in his 11+sec z thanks if you can help Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.