Where would I get Steel Channel w/wings for supports like ZF

[Sleeper-Z]

Well, I'm either being cheap or smart, but I'm leaning towards smart. I'm trying to locate some steel channel with wings as shown. I don't want to buy some sort of "kit" but just bare channel so it will be cheap, if worse comes to worse, I'll buy regular channel and just weld off of that, but I like the idea of the wings.

 

Also, does anyone here know what the dimensions are for the floor support on the 240z's that Zedd Findings makes?

 

 

 

Great website you guys have here. I've found everything i read useful information which is rare on automotive forums.

 

Thanks!

Steven M.

[Guest Anonymous]

Ive got a set laying in the basement. I can tell you that they go from the inner rocker pannel at the door to the trans tunnel where the floor turns up about 1.5 inches. The front of the pan stops where the factory seam is. It does not turn up to meet the fire wall. At the rear they turn up about four inches past the factory seam for the rear of the floor pan. There will probably be some areas that you have to fab. I need to add alot of metal at the fire wall area. Plenty from side to side unless you have rust in the inner rocker pannels. Should be plenty of metal to the rear of the pan but you may need to add some material to form the rear corners. If you cut at the factory seams and don't need to remove any other metal, you've got it made. Hope that helps.

Mark

[Trevor]

JC Whitney sells a similar flanged steel channel part # 18ZX8169N here:

http://www.jcwhitney.com/webapp/wcs/stores/servlet/ProductDisplay?productId=2615&catalogId=10101&langId=-1&storeId=10101

 

2" x 3/4" x 36" for $12

[Sleeper-Z]

alrite cool, now that i got the right name for them 'floor support channel' i've been able to find alot of sources. thanks for the quick replies!