Guest xbangu Posted October 29, 2004 Share Posted October 29, 2004 This is what going on, I have 240Z with a turbo engine. My idle can set it at range from 0.9 to 1.7 note: using the idle screws one on the manifold and the other in the AFM doesnt seem to help at all. Only increase, but hardly go down. (adjusting the AFM itself) At idling 0.9, when driving i can go pass 3.0rpm at any gears if it's at 1.3-1.4 I can go up to like 3.6-3.7rpm if at 1.5-1.7 i can go you to 4.5rpm have anyone been in this situation before??? Quote Link to comment Share on other sites More sharing options...
Guest xbangu Posted November 21, 2004 Share Posted November 21, 2004 This is what I did so far to try to get my car idle correctly. 1. Replace with a known working AFM 2. Replace ECU 3. Replace all the holes on the manifold. .....still no luck..... anyone here ahave any other suggestion and does anyone hin here know a Z expert shop near by so I can take my car there..... thanks Quote Link to comment Share on other sites More sharing options...
BrandonsZ Posted November 22, 2004 Share Posted November 22, 2004 I bet you have a sensor down, the system sounds like it's in limp mode. check the computer codes. Quote Link to comment Share on other sites More sharing options...
Guest xbangu Posted November 23, 2004 Share Posted November 23, 2004 Ok, one of my sensor might be bad.. and how do I check the computer codes?? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.